Moxa Technologies MiiNePort E2-H User Manual page 73

MiiNePort E2/E3
No. AT command
21 AT&V
22 AT&W
S Registers
No. S Register
1 S0
2 S1
3 S2
4 S3
5 S4
6 S5
7 S6
8 S7
9 S8
10 S9
11 S10
12 S11
13 S12
TCP alive check time
Setting
0 to 99 min
0 min: The TCP connection is not closed due to an idle TCP connection.
1 to 99 min: The module automatically closes the TCP connection if there is no TCP activity for the given time.
After the connection is closed, the module starts listening for another host's TCP connection.
Local TCP port
Setting
1 to 65535
The Local TCP port is the TCP port that the MiiNePort uses to listen to connections, and that other devices
must use to contact the MiiNePort. To avoid conflicts with well-known TCP ports, the default is set to 4001.
MCSC Mode
After selecting MCSC mode, you will be able to configure Channel 1 and Channel 2. MCSC mode is designed so
that the two channels work independently. Click the Modify button of a channel to update the channel's
configuration.
Description
View settings
Write current settings to flash for next boot-up
Description & default value
Ring to auto-answer (default=0)
Ring counter (always=0)
Escape code character (default=43 ASCII "+")
Return character (default=13 ASCII)
Line feed character (default=10 ASCII)
Backspace character (default= 8 ASCII)
Wait time for dial tone (always=2, unit=sec)
Wait time for carrier (default=3, unit=sec)
Pause time for dial delay (always=2, unit=sec)
Carrier detect response time (always=6, unit 1/10 sec)
Delay for hang up after carrier (always=14, unit 1/10 sec)
DTMF duration and spacing (always=100 ms)
Escape code guard time (default=50, unit 1/50 sec), to control the
idle time for "+++"
Factory Default
7 min
Factory Default
4001
7-24
Web Console Configuration
Remarks
Remarks
no action applied
no action applied
no action applied
no action applied
no action applied
no action applied
Necessity
Required
Necessity
Required