MiiNePort E2/E3
Serial command mode trigger
Command code: CT
Command parameters: N/A
Reply parameters: serial command mode trigger index as shown in the following table.
0
Disable
1
H/W control pin(DIO1)
2
Activated by characters
3
Activated by break signal
Note that this configuration is valid only if port 1's operation mode is not set to MCSC.
?GCT
!GCT01
Serial command mode trigger characters
Command code: CC
Command parameters: N/A
Reply parameters: serial command mode trigger characters, in hex, separated by a semicolon (;).
Note that this configuration is valid only if the serial command mode trigger method is set to Activated by
characters.
?GCC
!GCC058;58;58
Serial command mode triggered only at boot up
Command code: CB
Command parameters: N/A
Reply parameters: 0 if serial command mode can be triggered at any time, or 1 if it can only be triggered at
boot up.
Note that this configuration is valid only if the serial command mode trigger method is set to Activated by
characters.
?GCB
!GCB01
Gratuitous ARP
Command code: VA
Command parameters: N/A.
Reply parameters: 1 and send period if gratuitous ARP is enabled; otherwise, reply 0.
?GVA
!GVA01;300
Introduction to SCM (Serial Command Mode) Command Set
System requests serial command mode trigger method for this MiiNePort.
MiiNePort reports serial command mode is triggered by DIO1.
System requests serial command mode trigger characters for this
MiiNePort.
MiiNePort reports serial command mode triggered by `XXX' (0x585858).
System requests serial command mode for this MiiNePort.
MiiNePort reports serial command mode can only be triggered by
characters at boot up.
System requests gratuitous ARP status for alert mail server.
MiiNePort reports gratuitous ARP as 'Enable' and send period as '300' sec.
A-15