MiiNePort E2/E3
?STC1;0;1↲
!STC0↲
TCP destination address
Command code: TI
Command parameters: Port index, MCSC channel index, destination address index (0 for destination address
and 1 to 3 for alternated addresses). Parameters are separated by a semicolon (;). For an MCSC-disabled port,
the channel index is 0.
Reply parameters: N/A
?STI1;0;0;192.168.1.2:4001
!STT0
TCP Client local port
Command code: TL
Command parameters: Port index, MCSC channel index, local port index, and TCP local port. Every parameter
is separated by semicolon (;). For MCSC-disabled port, MCSC channel index shall be 0.
Reply parameters: N/A
?STL1;2;0;5002↲
!STL0↲
TCP max connection
Command code: TM
Command parameters: Port index, MCSC channel index, and maximum connection number. Parameters are
separated by a semicolon (;). For an MCSC-disabled port, the channel index is 0.
Reply parameters: N/A
?STM1;1;3
!STM0
TCP ignore jammed IP
Command code: TJ
Command parameters: Port index, MCSC channel index, and ignore jammed IP setting (0 for disable and 1 for
enable). Parameters are separated by a semicolon (;). For an MCSC-disabled port, the channel index is 0.
Reply parameters: N/A
?STJ1;2;0
!STJ0
Introduction to SCM (Serial Command Mode) Command Set
System sets TCP client connection control as 'Any character / None' for port
1.
MiiNePort reports command executed successfully.
System sets destination address as '192.168.1.2' and port as '4001' for
port 1.
MiiNePort reports command executed successfully.
System sets TCP client local port as '5002' for port 1's channel 2 (MCSC
enabled).
MiiNePort reports command executed successfully.
System sets maximum connection number as '3' for port 1 and channel 1.
MiiNePort reports command executed successfully.
System sets ignore jammed IP policy as 'Disable' for port 1's channel 2.
MiiNePort reports command executed successfully.
A-25