Moxa Technologies MiiNePort E2-H User Manual page 116

MiiNePort E2/E3
TCP alive check time
Command code: TA
Command parameters: Port index, MCSC channel index, and TCP alive check time. Parameters are separated
by a semicolon (;).
Reply parameters: N/A
?STA1;0;5
!STA0
TCP port
Command code: TP
Command parameters: Port index, MCSC channel index, and TCP local port. Every parameter is separated by
semicolon (;). For MCSC-disabled port, channel index shall be 0.
Reply parameters: N/A
?STP1;0;4100↲
!STP0↲
Command code: TO
Command parameters: Two numbers separated by a semicolon (;) denotes port index and MCSC channel index.
For MCSC-disabled port, channel index shall be 0.
Reply parameters: TCP port
?STO1;0;966↲
!STO0↲
Command code: TD
Command parameters: Two numbers separated by a semicolon (;) denotes port index and MCSC channel index.
For MCSC-disabled port, channel index shall be 0.
Reply parameters: 1 (Enable) or 0 (Disable)
?STD1;0;1↲
!STD0↲
TCP client connection control
Command code: TC
Command parameters: Port index, MCSC channel index, and client connection control setting. Every parameter
is separated by semicolon (;). For MCSC-disabled port, channel index shall be 0.
Reply parameters: N/A
0 Start up / None
1 Any character / None
2 Any character / Inactivity time
3 DSR On / DSR OFF
4 DSR On / None
5 DCD On / DCF OFF
6 DCD On / None
Introduction to SCM (Serial Command Mode) Command Set
System sets port 1's TCP alive check time to `5' minutes.
MiiNePort reports command executed successfully.
System sets TCP port as '4100' for port 1.
MiiNePort reports command executed successfully.
System sets TCP command port as '966' for port 1.
MiiNePort reports command executed successfully.
System sets allow driver control policy as 'enable' for port1.
MiiNePort reports command executed successfully.
A-24