MiiNePort E2/E3
TCP ignore jammed IP
Command code: TJ
Command parameters: Two numbers separated by a semicolon (;) denote port index and MCSC channel index.
For an MCSC-disabled port, the channel index is 0.
Reply parameters: 1 (Enable) or 0 (Disable)
?GTJ1;2
!GTJ01
TCP client local port
Command code: TL
Command parameters: Three numbers separated by semicolons (;) denote port index, MCSC channel index,
and local port index. For MCSC-disabled ports, the channel index is 0.
Reply parameters: TCP port.
?GTL1;0;0↲
!GTL05002
TCP inactivity time
Command code: TV
Command parameters: Two numbers separated by a semicolon (;) denote port index and MCSC channel index.
For an MCSC-disabled port, the channel index is 0.
Reply parameters: TCP inactivity time.
?GTV1;0
!GTV00
UDP destination address
Command code: UD
Command parameters: Three numbers separated by a semicolon (;) denote port index, MCSC channel index,
and destination address index from 1 to 4. For an MCSC-disabled port, the channel index is 0.
Reply parameters: Begin address – End address: port
?GUD1;0;3
!GUD0192.168.1.3-192.168.1.8
:4001
UDP local listen port
Command code: UP
Command parameters: Two numbers separated by a semicolon (;) denote port index and MCSC channel index.
For an MCSC-disabled port, the channel index is 0.
Reply parameters: local listen port
?GUP1;0
!GUP04001
Introduction to SCM (Serial Command Mode) Command Set
System requests jammed IP policy for port 1's channel 2.
MiiNePort reports ignore jammed IP as 'Enable'.
System requests for TCP client local port setting for port 1.
MiiNePort reports TCP client local port is 5002.
System requests inactivity time for port 1.
MiiNePort reports inactivity time as '0'.
System requests UDP destination address 3 for port 1.
MiiNePort reports UDP destination address is from '192.168.1.3' to
'192.168.1.8' and port as '4001'.
System requests UDP local listen port for port 1.
MiiNePort reports UDP local listen port as '4001'.
A-13