MiiNePort E2/E3
NECI (utility accessibility)
Command code: BU
Command parameters: 1 if NECI is enabled, 0 otherwise.
Reply parameters: N/A
?SBU1
!SBU0
IP configuration
Command code: NC
Command parameters: MiiNePort's IP configuration index as shown in the following table
Reply parameters: N/A
0
Static
1
DHCP
2
DHCP/BOOTP
3
BOOTP
4
AutoIP
?SNC0
!SNC0
IP address
Command code: NI
Command parameters: MiiNePort's IP address.
Reply parameters: N/A
?SNI192.168.1.2
!SNI0
Netmask
Command code: NM
Command parameters: MiiNePort's Netmask address.
Reply parameters: N/A
?SNM255.255.255.0
!SNM0
Gateway
Command code: NG
Command parameters: MiiNePort's Gateway address.
Reply parameters: N/A
?SNG192.168.1.254
!SNG0
Introduction to SCM (Serial Command Mode) Command Set
System sets NECI setting as 'Enable' for this MiiNePort.
MiiNePort reports command executed successfully.
System sets IP configuration as 'Static'.
MiiNePort reports command executed successfully.
System sets IP address as '192.168.1.2'.
MiiNePort reports command executed successfully.
System sets Netmask as '255.255.255.0'.
MiiNePort reports command executed successfully.
System sets Gateway as '192.168.1.254'.
MiiNePort reports command executed successfully.
A-17