Moxa Technologies MiiNePort E2-H User Manual page 106

MiiNePort E2/E3
E-modem alive check time
Command code: EA
Command parameters: Two numbers separated by a semicolon (;) denotes port index and MCSC channel index.
For MCSC-disabled port, channel index shall be 0.
Reply parameters: TCP alive check time
?GEA1;0↲
!GEA05↲
E-modem local listen port
Command code: EP
Command parameters: Two numbers separated by a semicolon (;) denotes port index and MCSC channel index.
For MCSC-disabled port, channel index shall be 0.
Reply parameters: local listen port
?GEP1;0↲
!GEP04001↲
DIO initial mode
Command code: PM
Command parameters: DIO port index. For the MiiNePort E2, the index is as follows:
Index DIO port
0 DIO0
1 DIO1
2 DIO2
3 DIO3
Reply parameters: 1 (output) or 0 (input); note that for the MiiNePort E2, this configuration is available if a
specific PIN function is set to DIO.
?GPM1
!GPM01
DIO initial state
Command code: PS
Command parameters: DIO port index. For the MiiNePort E2, the index is as follows:
Index DIO port
0 DIO0
1 DIO1
2 DIO2
3 DIO3
Reply parameters: 1 (high) or 0 (low), note that this function is configuration only if specific DIO port is set to
initial output.
?GPS0↲
!GPS00↲
Introduction to SCM (Serial Command Mode) Command Set
System requests for TCP alive check time for port 1.
MiiNePort reports TCP alive check time is '5' minutes.
System requests UDP local listen port for port 1.
MiiNePort reports UDP local listen port is '4001'.
MiiNePort E2 PIN number
JP3 - PIN1
JP3 - PIN4
JP3 - PIN2
JP3 - PIN3
System requests DIO1's initial mode for this MiiNePort.
MiiNePort reports DIO1's initial mode as 'output'.
MiiNePort E2 PIN number
JP3 - PIN1
JP3 - PIN4
JP3 – PIN2
JP3 - PIN3
System requests DIO0's initial state for this MiiNePort.
MiiNePort reports DIO0's initial state is 'low'.
A-14