Moxa Technologies MiiNePort E2-H User Manual page 132

MiiNePort E2/E3
DIO initial state
Command code: PS
Command parameters: DIO port index. For the MiiNePort E2, the index is as follows:
Index DIO port
0 DIO0
1 DIO1
2 DIO2
3 DIO3
Reply parameters: 1 (high) or 0 (low) , note that this function is configuration only if specific DIO port is set to
initial output.
?RPS0
!RPS00
Serial command mode trigger
Command code: CT
Command parameters: N/A
Reply parameters: serial command mode trigger index as shown in the following table.
0 Disable
1 H/W control pin(DIO1)
2 Activated by characters
3 Activated by break signal
Note that this configuration is valid only if port 1's operation mode is not set to MCSC.
?RCT
!RCT01
Serial command mode trigger characters
Command code: CC
Command parameters: N/A
Reply parameters: serial command mode trigger characters, in hex, separated by a semicolon (;).
Note that this configuration is valid only if serial command mode trigger method is set to `Activated by
characters'.
?RCC
!RCC058;58;58
Serial command mode trigger only at boot up
Command code: CB
Command parameters: N/A
Reply parameters: 0 if serial command mode can be triggered at any time, or 1 if it can only be triggered at
boot up.
Note that this configuration is valid only if serial command mode trigger method is set to `Activated by
characters'.
?RCB
!RCB01
Introduction to SCM (Serial Command Mode) Command Set
MiiNePort E2 PIN number
JP3 - PIN1
JP3 - PIN4
JP3 – PIN2
JP3 - PIN3
System requests DIO0's initial state for this MiiNePort.
MiiNePort reports DIO0's initial state as 'low'.
System requests serial command mode trigger method for this MiiNePort.
MiiNePort reports serial command mode is triggered by DIO1.
System requests serial command mode trigger characters for this
MiiNePort.
MiiNePort reports serial command mode triggered by `XXX' (0x585858).
System requests serial command mode for this MiiNePort.
MiiNePort reports serial command mode can only be triggered by
characters at boot up.
A-40