Moxa Technologies MiiNePort E2-H User Manual page 130

MiiNePort E2/E3
TCP client local port
Command code: TL
Command parameters: Two numbers separated by a semicolon (;) denotes port index and MCSC channel index.
For MCSC-disabled port, channel index shall be 0.
Reply parameters: TCP port.
?RTL1;0↲
!RTL05002
TCP max connection
Command code: TM
Command parameters: Two numbers separated by a semicolon (;) denote port index and MCSC channel index.
For an MCSC-disabled port, the channel index is 0.
?RTM1;1
!RTM04
TCP ignore jammed IP
Command code: TJ
Command parameters: Two numbers separated by a semicolon (;) denote port index and MCSC channel index.
For an MCSC-disabled port, the channel index is 0.
Reply parameters: 1 (Enable) or 0 (Disable).
?RTJ1;2
!RTJ01
TCP inactivity time
Command code: TV
Command parameters: Two numbers separated by a semicolon (;) denote port index and MCSC channel index.
For an MCSC-disabled port, the channel index is 0.
Reply parameters: TCP inactivity time.
?RTV1;0
!RTV00
UDP destination address
Command code: UD
Command parameters: Three numbers separated by a semicolon (;) denote port index, MCSC channel index,
and destination address index from 1 to 4. For an MCSC-disabled port, the channel index is 0.
Reply parameters: Begin address – End address: port
?RUD1;0;3
!RUD0192.168.1.3-192.168.1.8
:4001
Introduction to SCM (Serial Command Mode) Command Set
System requests for TCP client local port setting for port 1.
MiiNePort reports TCP client local port is 4001.
System requests maximum connection number for port 1 and channel 1.
MiiNePort reports maximum connection number as '4'.
System requests jammed IP policy for port 1's channel 2.
MiiNePort reports ignore jammed IP as 'Enable'.
System requests inactivity time for port 1.
MiiNePort reports inactivity time as '0'.
System requests UDP destination address 3 for port 1.
MiiNePort reports UDP destination address is from '192.168.1.3' to
'192.168.1.8' and port as '4001'.
A-38