MiiNePort E2/E3
RFC2217 local listen port
Command code: FP
Command parameters: Two numbers separated by a semicolon (;) denotes port index and MCSC channel index.
For MCSC-disabled port, channel index shall be 0.
Reply parameters: local listen port
?GFP1;0↲
!GFP01234↲
TCP Server Connection Control
Command code: TS
Command parameters: Two numbers separated by a semicolon (;) denote port index and MCSC channel index.
For an MCSC-disabled port, the channel index is 0.
Reply parameters: TCP server connection control as shown in the following table.
0
Always accept
1
Accept with DSR on
?GTS1;0
!GTS00
TCP Alive Check Time
Command code: TA
Command parameters: Two numbers separated by a semicolon (;) denote port index and MCSC channel index.
For an MCSC-disabled port, the channel index is 0.
Reply parameters: TCP alive check time
?GTA1;0
!GTA05
TCP Port
Command code: TP
Command parameters: Two numbers separated by a semicolon (;) denote port index and MCSC channel index.
For an MCSC-disabled port, the channel index is 0.
Reply parameters: TCP port
?GTP1;0
!GTP04100
TCP command port
Command code: TO
Command parameters: Two numbers separated by a semicolon (;) denotes port index and MCSC channel index.
For MCSC-disabled port, channel index shall be 0.
Reply parameters: TCP port
?GTO1;0↲
!GTO0966↲
Introduction to SCM (Serial Command Mode) Command Set
System requests for RFC2217 local listen port for port 1.
MiiNePort reports RFC2217 local listen port is '1234'.
System requests TCP server connection control for port 1.
MiiNePort reports incoming policy as 'Always accept'.
System requests TCP alive check time for port 1.
MiiNePort reports TCP alive check time as '5' minutes.
System requests TCP port for port 1.
MiiNePort reports TCP port as '4100'.
System requests for TCP command port for port 1.
MiiNePort reports TCP command port is '966'.
A-11