Moxa Technologies MiiNePort E2-H User Manual page 118

MiiNePort E2/E3
TCP inactivity time
Command code: TV
Command parameters: Port index, MCSC channel index, and inactivity timeout setting. Parameters are
separated by a semicolon (;). For an MCSC-disabled port, the channel index is 0.
Reply parameters: N/A
?STV1;0;10
!STV0
UDP destination address
Command code: UD
Command parameters: Port index, MCSC channel index, destination address index (1 to 4), and destination
addresses. Parameters are separated by a semicolon (;). For an MCSC-disabled port, the channel index is 0.
The destination addresses is formatted as Begin address – End address: UDP port.
Reply parameters: N/A
?SUD1;0;3;192.168.1.3-192.16
8.1.8:4001
!SUD0
UDP local listen port
Command code: UP
Command parameters: Port index, MCSC channel index, and local UDP port. Parameters are separated by a
semicolon (;). For an MCSC-disabled port, the channel index is 0.
Reply parameters: N/A
?SUP1;0;4001
!SUP0
E-modem TCP alive check time
Command code: EA
Command parameters: Port index, MCSC channel index, and TCP alive check time. Every parameter is
separated by semicolon (;). For MCSC-disabled port, channel index shall be 0.
Reply parameters: N/A.
?SEA1;0;5↲
!SEA0↲
E-modem local listen port
Command code: EP
Command parameters: Port index, MCSC channel index, and TCP local port. Every parameter is separated by
semicolon (;). For MCSC-disabled port, channel index shall be 0.
Reply parameters: N/A
?SEP1;0;4100↲
!SEP0↲
Introduction to SCM (Serial Command Mode) Command Set
System sets inactivity time as '10' ms for port 1.
MiiNePort reports command executed successfully.
System sets UDP destination address 3 is from '192.168.1.3' to
'192.168.1.8' and port as '4001' for port 1.
MiiNePort reports command executed successfully.
System sets UDP local listen port as '4001' for port 1.
MiiNePort reports command executed successfully.
System sets port 1's TCP alive check time as '5' for port 1.
MiiNePort reports command executed successfully.
System sets TCP port as '4100' for port 1.
MiiNePort reports command executed successfully.
A-26