Moxa Technologies MiiNePort E2-H User Manual page 45

MiiNePort E2/E3
The usage instructions will show up for user's reference.
------------------------------------------------------------------------------
NPort Command-Line Interface Ver2.0 Build 16052400
------------------------------------------------------------------------------
Usage:
1. NPort Driver operation:
npcli /driver [/install | /uninstall | /upgrade] [PATH_NAME]
/install
/uninstall
/upgrade
PATH_NAME
2. RealCOM port operation:
npcli /driver /add IP_ADDR /port PORT_NO /com COM_NO [/txmode [hiperf |
classical]] [/fifo [enable | disable]] [/flush [fast | normal]]
npcli /driver /remove /com [COM_NO | all]
/add
/port
/com
/txmode
/fifo
/flush
/remove
3. NPort devices operation:
npcli /devicd /search
npcli /device /set ID /network [/ip IP_ADDR] [/mask SUBNET]
[/gateway IP_ADDR] [/password CIPHER]
npcli /device /apply ID [/password CIPHER]
/search
/set
/port
/password
/network
/ip
/mask
/gateway
/apply
4. Examples
npcli /driver /install D:\Users\drvmgr_setup_Ver1.19.0_Build_15122492
npcli /driver /uninstall
npcli /driver /add 192.168.127.254 /port 1 /com 3
npcli /driver /add 192.168.127.254 /port 2 /com 4 /flush normal
npcli /device /search
npcli /device /set 1 /network /ip 192.168.10.7 /mask 255.255.255.0
Install specified driver to host.
Uninstall current installed driver from host.
Upgrade specified driver without modifying the mapped ports.
Specify the installer file of NPort Driver Manager to install
or upgrade.
Add a RealCOM with a valid IP address (IP_ADDR).
Specify the NPort port number (PORT_NO) to add.
Specify the COM number to add or remove (COM_NO).
Set the TX mode as hi-performance (hiperf) or classical. The
default is hiperf.
Set the FIFO as enable or disable. The default is enable.
Set to enable fast flush(fast) or disable fast flush(normal).
The default is fast.
Remove specified COM number (COM_NO) or all RealCOM ports.
Search the NPort and store the list to the memory.
Specify the ID to set. Users must specify one of the searched
NPorts for further operations. The default is 1.
Specify the NPort port number (PORT_NO) to set.
Specify the password (CIPHER) if the NPort has one.
Set to change the network settings.
Change the IP address (IP_ADDR) of NPort.
Change the subnet mask (SUBNET) of NPort.
Change the IP address (IP_ADDR) of gateway.
Specify the ID to save changes and restart the NPort.
Utility Console and Driver Installation
6-11