MiiNePort E2/E3
Netmask
Command code: NM
Command parameters: N/A
Reply parameters: MiiNePort's Netmask address.
?RNM
!RNM0255.255.255.0
Gateway
Command code: NG
Command parameters: N/A
Reply parameters: MiiNePort's Gateway address.
?RNG
!RNM0255.255.255.255
DNS
Command code: ND
Command parameters: The index (1 or 2) of DNS server.
Reply parameters: MiiNePort's DNS address.
?RND1
!RND0192.168.1.2
PHY Speed
Command code: NS
Command parameters: N/A
Reply parameters: MiiNePort's PHY speed as follows:
0
PHY auto negotiation is enabled.
10
PHY speed is forced to 10Mbps with half duplex
11
PHY speed is forced to 10Mbps with full duplex
100
PHY speed is forced to 100Mbps with half duplex
101
PHY speed is forced to 100Mbps with full duplex
?RNS
!RNS00
Enable/Disable SNMP
Command code: MS
Command parameters: N/A
Reply parameters: 1 (Enable) or 0 (Disable) MiiNePort's SNMP agent.
?RMS
!RMS01
Introduction to SCM (Serial Command Mode) Command Set
System requests Netmask address for this MiiNePort.
MiiNePort reports netmask as '255.255.255.0'.
System requests Gateway address for this MiiNePort.
MiiNePort reports Gateway address as '255.255.255.255'.
System requests DNS server 1 address for this MiiNePort.
MiiNePort reports DNS server 1 address as '192.168.1.2'.
System requests PHY speed setting for this MiiNePort.
MiiNePort reports PHY speed is determined by PHY auto negotiation
function.
System requests Enable/Disable SNMP agent for this MiiNePort.
MiiNePort reports SNMP agent as 'Enable'.
A-30