Agilent Technologies B1500A User Manual page 89

Table 3-3
Agilent 16493J Interlock Cable, 3 m or 1.5 m
Agilent 16493L GNDU Cable, 3 m or 1.5 m
Agilent 16493K
1.5 m, for the Kelvin connection
16495F provides the inputs 1 to 12 (6 Kelvin).
16495H provides the inputs 1 to 6 (3 Kelvin).
16495J provides the inputs 1 to 8 (4 Kelvin).
Agilent 16494A Triaxial Cable, 3 m or 1.5 m,
for non-Kelvin connection
16495H provides the inputs 1 to 6.
16495J provides the inputs 1 to 8.
Agilent 16493P SPGU Cable, 3 m or 1.5 m
16495H provides the inputs 7 to 12.
16495J provides the inputs 9 to 12.
Agilent N1300A CMU Cable
16495H provides the inputs 7 to 12.
16495J provides the inputs 9 to 12.
a. Use Agilent 16494B Kelvin Triaxial Cable to connect to Agilent E5250A
b. To extend the four-terminal pair (4TP) connection to the connector plate
To Connect Connector Plate
Cables
a
Kelvin Triaxial Cable, 3 m or
Low Leakage Switch Mainframe or the connector plate for Agilent 4142B
Modular DC Source/Monitor by the Kelvin connection.
inputs, connect the Hcur and Hpot cables together and the Lcur and Lpot
cables together by using the BNC T-type adapter (female-female-male, Agi-
lent part number 1250-2405), then connect them to the connector plate inputs.
To extend the 4TP connection to the DUT interface, connect the cables to the
connector plates input connectors individually, and connect the Hcur and
Hpot terminals together and the Lcur and Lpot terminals together on the DUT
interface. See Figure 3-17.
It is ok to leave open the ground wire extended from the CMU cable.
Agilent B1500A User's Guide, Edition 10
Connector
odd number
even number
odd number
even number
odd number
even number
odd number
b
, 3 m or 1.5 m
even number
Installing Accessories
B1500A Terminals
Plate
Intlk Interlock
GNDU GNDU
SMU
or SMU
SPGU
or
Hcur/Hpot
or CMU
Installation
Force
Sense
Force
Output 1
Output 2
Lcur/Lpot
3- 15