Table of Contents
Advertisement
2.7
ATZ Set all current parameters to user defined profile
sets all current parameters to the user profile stored with AT&W. If a connection is in progress, it will be ter-
ATZ
minated.
All defined GPRS contexts which are not activated or not online will be undefined (see AT+CGDCONT).
The user defined profile is stored to the non-volatile memory.
Syntax
Exec Command
ATZ[<value>]
Response(s)
OK
Reference(s)
V.250
Parameter Description
(num)
<value>
[0]
Notes
•
First the profile will be set to factory default (see AT&F). If there is a valid user profile (stored with AT&W), this
profile will be loaded afterwards.
•
Any additional commands on the same command line may be ignored. A delay of 300 ms is required before
next command is sent, otherwise "OK" response may be corrupted.
MC55_ATC_V04.00
Confidential / Released
PIN
!
Reset to user profile
Page 36 of 475
ASC0 ASC1
MUX1
MUX2
%
%
%
%
MUX3 Charge
Last
%
!
!
!
3/17/06
Advertisement
Table of Contents
