Table of Contents
Advertisement
11.10
AT+CGQREQ Quality of Service Profile (Requested)
Syntax
Test Command
AT+CGQREQ=?
Response(s)
+CGQREQ: <PDP_type>, (list of supported <precedence>s), (list of supported <delay>s), (list of
supported <reliability>s), (list of supported <peak>s), (list of supported <mean>s)
OK
Read Command
AT+CGQREQ?
Response(s)
[+CGQREQ: <cid>, <precedence>, <delay>, <reliability>, <peak>, <mean>]
[+CGQREQ: ...]
Write Command
AT+CGQREQ=[<cid>[, <precedence>[, <delay>[, <reliability>[, <peak>[, <mean>]]]]]]
Response(s)
OK
ERROR
+CME ERROR
Reference(s)
GSM 07.07
Command Description
The test command returns values supported as a compound value. If the MT supports several PDP types, the
parameter value ranges for each PDP type are returned on a separate line.
The read command returns the current settings for each defined context. If no requested profile was explicitly
specified for a context, simply OK will be returned, but default values will be used for that context.
This command allows the TE to specify a Quality of Service Profile that is used when the MT sends an Activate
PDP Context Request message to the network.
The set command specifies a profile for the context identified by the (local) context identification parameter,
<cid>.
A special form of the set command,
to become undefined.
and
will undefine the QoS profiles of every context which is not active or not online.
AT&F
ATZ
Parameter Description
(num)
<cid>
Parameter specifies a particular PDP context definition. The parameter is local to the TE-MT interface and is
used in other PDP context-related commands.
1...2
(num)
<precedence>
Precedence class
[0]
1
MC55_ATC_V04.00
Confidential / Released
PIN
%
+CGQREQ=<cid>
causes the requested profile for context number
network subscribed value
High Priority
Service commitments shall be maintained ahead of precedence classes 2 and
3
Page 284 of 475
ASC0 ASC1
MUX1
MUX2
%
%
%
%
MUX3 Charge
Last
%
!
!
!
<cid>
3/17/06
Advertisement
Table of Contents
