Table of Contents
Advertisement
Notes
•
Due to its restrictive value range, indicator "call" does not clearly reflect specific call states (such as alerting,
active, held etc.), but rather serves to trigger the application to retrieve the new call status from the list of cur-
rent calls with the AT commands AT^SLCC,
•
If
setting <succ>="verbose", indicator "call" will be issued also when a traffic channel is estab-
AT^SCFG
lished, or when a call enters states "terminating" or "dropped" (see
In these cases, the relevant information about the cause of the display is available only from AT command
AT^SLCC.
Examples
EXAMPLE 1
^SYSSTART
AT+CPIN=9999
OK
AT+CIND?
+CIND: 5,99,1,0,0,0,0,0
OK
AT+CMER=2,0,0,2
OK
+CIEV: battchg,5
+CIEV: signal,99
+CIEV: service,1
+CIEV: sounder,0
+CIEV: message,0
+CIEV: call,0
+CIEV: roam,0
+CIEV: smsfull,0
+CIEV: rssi,5
ATD0123456;
OK
+CIEV: sounder,1
+CIEV: call,1
+CIEV: sounder,0
+CIEV: call,0
NO CARRIER
AT+CIND=,,,0,,0
OK
ATD0123456;
OK
NO CARRIER
EXAMPLE 2
Deactivation of indicator "sounder" via
AT+CIND?
+CIND: 5,99,1,0,1,0,0,0,4
OK
AT+CIND=,,,0
OK
EXAMPLE 3
Deactivation of indicator "sounder" via
AT^SIND="sounder",0
^SIND: sounder,0,0
OK
MC55_ATC_V04.00
Confidential / Released
or AT^SCNI.
AT+CLCC
The battery is either full or no battery is connected to the ME. The bit
error rate of the signal quality is not available (since there is no call in
progress). The ME is registered to its home network.
Now activate the Indicator Event Report with AT+CMER.
Full receive signal strength.
Make a call.
A set of "+CIEV" URCs is received.
Called party hangs up.
Deregister the indicators "sounder" and "call".
Dial the same call.
This time, no URCs are displayed.
Called party hangs up.
AT+CIND
Query the current status of indicators.
To deactivate indicator "sounder" (= fourth item in list of indicators).
AT^SIND
To deactivate indicator "sounder".
Page 64 of 475
Call Status
Information).
3/17/06
Advertisement
Table of Contents
