At+Clir Calling Line Identification Restriction - Siemens Brodersen MC55 AT Command Manual

9.10

AT+CLIR Calling line identification restriction

The command refers to the GSM supplementary service CLIR (Calling Line Identification Restriction).
AT+CLIR
Syntax
Test Command
AT+CLIR=?
Response(s)
+CLIR: (list of supported <n>s)
OK
Read Command
AT+CLIR?
Response(s)
+CLIR<n>, <m>
OK
ERROR
+CME ERROR: <err>
Write Command
AT+CLIR=[<n>]
Response(s)
OK
ERROR
+CME ERROR: <err>
Reference(s)
GSM 07.07
Parameter Description
(num)
<n>
Parameter shows the settings for outgoing calls:
(P)
[0]
1
2
(num)
<m>
Parameter shows the subscriber CLIR service status in the network:
0
1
2
3
4
Note
• The settings made with AT+CLIR=1 or AT+CLIR=2 are used for all outgoing calls until the ME is switched off
or AT+CLIR=0 is used.
MC55_ATC_V04.00
Confidential / Released
PIN
%
Presentation indicator is used according to the subscription of the CLIR service
CLIR invocation
CLIR suppression
CLIR not provisioned
CLIR provisioned in permanent mode
Unknown (e.g. no network, etc.)
CLIR temporary mode presentation restricted
CLIR temporary mode presentation allowed
Page 210 of 475
ASC0 ASC1 MUX1 MUX2
% % % %
MUX3 Charge Last
% ! ! !
3/17/06