Table of Contents
Advertisement
128
129
(num)
<CLI validity>
0
1
2
Notes
•
If the active call is a CSD call, and a waiting call is received, then the ME produces a BREAK while still in
online mode, and displays
-
the +CCWA URC (as above) when the ME goes back to command mode while the waiting call is still active
and can be accepted;
-
or the ^SCWA URC (as above) when the ME goes back to command mode after the waiting call has
ended.
•
With the AT+CHLD command, it is possible to establish a multiparty call or to set the active voice call on hold
and then accept a waiting voice call (not possible with fax and data call). See also
•
Users should be aware that if call waiting is activated (<mode>=1), the presentation of URCs needs to be
enabled, too (<n>=1).
Otherwise, on the one hand, a waiting caller would be kept waiting due to lack of BUSY signals, while, on the
other hand, the waiting call would not be indicated to the called party.
•
The AT+CCWA command offers a broad range of options according to the GSM specifications. However,
when you attempt to enable call waiting for a
ported , the setting will not take effect regardless of the response returned. The responses in these cases vary
with the network (for example "OK", "Operation not allowed", "Operation not supported" etc.). To make sure
check the current call waiting settings with <mode>=2.
•
The AT+CCWA command has been implemented with the full set of
GSM 07.07. For actual applicability of SS call waiting to a specific service or service group (a specific
value) please consult table A.1 of GSM 02.04
<class>
•
Despite the specifications stated in GSM 02.04 call waiting is not handled uniformly among all networks:
GSM 02.04, Annex A, provides the following specification:
"The applicability of call waiting refers to the telecommunication service of the active call and not of the waiting
call. The incoming, waiting, call may be of any kind." Nevertheless, networks do differ on the actual imple-
mentation of the service. For example, the activation of call waiting for
works to send a call waiting indication if a call "of any kind" comes in during an active fax call, but others may
(with the same settings active) indicate a waiting fax call during any kind of active call. Thus, the only reliable
way to receive or prevent a call waiting indication under any circumstances and in any network, is to activate
or deactivate call waiting for all tele- and bearer services
MC55_ATC_V04.00
Confidential / Released
number restricted
Otherwise
CLI valid
CLI has been withheld
CLI is not available
<class>
Page 204 of 475
for which the service is not provisioned or not sup-
<class>
<class>
(<class>
255).
AT+CHLD
parameters according to
4, "fax", causes some net-
3/17/06
Advertisement
Table of Contents
