Table of Contents
Advertisement
11.4
AT+CGAUTO Automatic response to a network request for PDP
context activation
Syntax
Test Command
AT+CGAUTO=?
Response(s)
+CGAUTO: (list of supported <n>s)
OK
Read Command
AT+CGAUTO?
Response(s)
+CGAUTO:
<n>
OK
Write Command
AT+CGAUTO=[<n>]
Response(s)
OK
ERROR
+CME ERROR
Reference(s)
GSM 07.07
Command Description
The test command returns the values of
The write command disables or enables an automatic positive response (auto-answer) to the receipt of a
Request PDP Context Activation message from the network. It also provides control over the use of the V.250
basic commands ATS0,
Parameter Description
(num)
<n>
0
1
(&F)(P)
3
Notes
•
It is allowed to have different
•
When the AT+CGAUTO=0 command is received, the MT will not perform a GPRS detach if it is attached. Sub-
sequently, when the MT announces a network request for PDP context activation by issuing the URC RING
or CRING, the TE may manually accept or reject the request by issuing the
ply ignore the network request.
MC55_ATC_V04.00
Confidential / Released
supported by the MT as a compound value.
<n>
and
for handling network requests for PDP context activation.
ATA
ATH
Disable automatic response for network requests for GPRS PDP context acti-
vation. GPRS network requests are manually accepted or rejected by the
command.
AT+CGANS
Enable automatic response for network requests for GPRS PDP context acti-
vation. GPRS requests are automatically accepted according to the description
below.
Modem compatibility mode. The automatic acceptance of both GPRS and
incoming CSD calls is controlled by the
the
and
ATA
ATH
requests or incoming CSD calls.
settings on different interfaces.
AT+CGAUTO
Page 271 of 475
PIN
ASC0 ASC1
MUX1
%
%
%
%
ATS0
commands, respectively, to accept or reject GPRS network
MUX2
MUX3 Charge
%
%
!
!
command. Manual control uses
command or may sim-
AT+CGANS
Last
!
3/17/06
Advertisement
Table of Contents
