7.13
ATS7 Set number of seconds to wait for connection completion
specifies the number of seconds the TA will wait for the completion of the call setup when answering or
ATS7
originating a data call. Also referred to as "no answer timeout". To put it plainly, this is the time to wait for the
carrier signal. If no carrier signal is received within the specified time, the TA hangs up.
Syntax
Read Command
ATS7?
Response(s)
<n>
OK
Write Command
ATS7=<n>
Response(s)
OK
ERROR
Reference(s)
V.250
Parameter Description
(num)(&W)(&V)
<n>
Number of seconds to wait for connection completion
(&F)
000...060
Notes
•
Command
is only applicable to data calls.
ATS7
•
Values greater than 60 cause no error, but
•
The correlation between
call setup may fail.
ATS0=<n>
Example: Call setup may fail if ATS7=30 and ATS0=20.
MC55_ATC_V04.00
Confidential / Released
PIN
will be restored to the maximum value of 60.
<n>
and
is important. If the called party has specified a high value for
ATS7
ATS0
Page 140 of 475
ASC0 ASC1
MUX1
!
%
!
%
MUX2
MUX3 Charge
!
!
!
!
Last
!
3/17/06