Ath Disconnect Existing Connection - Siemens Brodersen MC55 AT Command Manual

7.9

ATH Disconnect existing connection

Syntax
Exec Command
ATH[<n>]
Response(s)
OK
Reference(s)
V.250
Command Description
Disconnect existing call from command line by local TE and terminate call.
Parameter Description
(num)
<n>
[0]
Notes
• OK is issued after circuit 109 (DCD) is turned off, if it was previously on.
• terminates every circuit switched call (voice, data or fax), even if it is issued via another interface. This
ATH
behavior is in accordance with ITU-T V.250; (07/97, "Hook control":
• clears any active PDP context or terminates any existing PPP connection, but only if issued on the same
ATH
interface where GPRS is used and if there is no pending network request for PDP context activation. It does
not affect PDP contexts and PPP connections on other interfaces (see also Chapter
of a network request for PDP context activation").
MC55_ATC_V04.00
Confidential / Released
PIN
!
disconnect from line and terminate call
Page 136 of 475
ASC0 ASC1 MUX1 MUX2
% % % %
"ATH is terminating any call in progress.").
MUX3 Charge Last
% ! ! !
"ATH Manual rejection
3/17/06