At+Clvl Loudspeaker Volume Level - Siemens Brodersen MC55 AT Command Manual

17.4

AT+CLVL Loudspeaker volume level

Syntax
Test Command
AT+CLVL=?
Response(s)
+CLVL: (list of supported<level>s)
OK
Read Command
AT+CLVL?
Response(s)
+CLVL: <level>
OK
ERROR
+CME ERROR: <err>
Write Command
AT+CLVL=<level>
Response(s)
OK
ERROR
+CME ERROR: <err>
Reference(s)
GSM 07.07
Parameter Description
(num)
<level>
Loudspeaker Volume Level
(D)
0...4
Notes
• The write command can only be used in audio mode 2 - 6.
• The values of the volume steps are specified with the parameters
brate>[4] of the
AT^SNFO
• As an alternative to AT+CLVL, you can use
used by both commands.
<outStep>
• Any change to
<level>
(or <outStep>) and then select another mode with AT^SNFS, the same step will be applied.
<level>
The only exception is audio mode 1 which is fixed to <level>=4 (or accordingly <outStep>=4).
• (or <outStep>) is stored non-volatile when the ME is powered down with
<level>
AT+CFUN=1,1.
MC55_ATC_V04.00
Confidential / Released
PIN
!
command.
AT^SNFO
(or <outStep>) takes effect in audio modes 2 to 6. That is, when you change
Page 403 of 475
ASC0 ASC1 MUX1 MUX2
% % %
<outCalibrate>[0],...<outCali-
and AT^SNFV. The parameter
MUX3 Charge
% % ! !
is identical with
<level>
or reset with
AT^SMSO
3/17/06
Last
!