Inserting A Module; Removing A Module - Viavi 8100 V2 Series User Manual

Inserting a module

The Platform 8000 must be switched off, and if it has a mains
power supply, the adapter cable must be unplugged
1 Slide the module into its slot.
2 When it is fully home, press against the screen-printed surface of the
module while tightening the securing screws. The screen-printed
surface of the plug-in must be flush with that of the receptacle.
3 Make sure that the two large captive screws of the plug-in are
screwed fully home.
NOTE
UHD modules use very powerful lasers: they must be connected
exclusively to optical connectors equipped with zirconium ferules.
Using connectors equipped with metallic ferrules could damage
the plug-in connector.

Removing a module

The Platform 8000 must be switched off, and if it has a mains
power supply, the adapter cable must be unplugged
1 Completely unscrew (up to the stop) the two captive screws securing
the module.
2 Carefully slide the module out of its slot.
Installing a module in a receptacle and removing it
User Manual 78000010220 Rev. 023
Chapter 2 Getting started
15