Chapter 3 Reflectometry measurements
Traffic Detection and connection quality indicator
Traffic Detection and connection quality
indicator
Traffic Detection
Traffic on the fiber under test is automatically detected and reported.
1
Press the S
A message indicates there is traffic on the fiber and asks you if you
wish to continue or not:
•
If you click on N
•
If you click on Y
NOTE
If the measurement is validated despite the traffic (key Y
next measurement will be automatically performed, even if traffic
is still detected on fiber.
If the measurement is cancelled (key N
pushed another time, the box asking if you wish to continue or
not is displayed.
The functioning of Traffic Detection is then indicated in the scaled down
representation of trace, on the upper left part of screen
Connection Quality indicator
An indicator of the state of the connection (Good / Bad) is given at the
beginning of an acquisition, whatever is the acquisition mode selected.
The connection quality indicator gives the following information:
64
/S
key to begin the measurement.
TART
TOP
, the measurement is not launched.
O
, the measurement is performed, despite the traffic.
ES
User Manual
O
78000010220 Rev. 023
ES
), and the S
TART
.
), the
/S
TOP