Reflectometry measurements
Chapter 3
Pressing the S
measurement. However, it is necessary to configure the measurement and
the type of results desired.
This chapter describes the different stages in a reflectometry measurement
made using an OTDR module.
The topics discussed in this chapter are as follows:
•
"Activating the OTDR function" on page 28
•
"Configuring the reflectometry test" on page 31
•
"Traffic Detection and connection quality indicator" on page 64
•
"Performing OTDR acquisitions" on page 65
•
"Results display" on page 75
•
"Advanced functions in Expert OTDR mode" on page 91
•
"Saving the trace(s) and generating a report" on page 111
•
"SLM (Smart Link Mapper) option" on page 116
•
"OptiPulses option" on page 122
•
"FTTA-SLM option" on page 125
•
"FTTH-SLM Software option" on page 146
•
"Smart Link Cable Option" on page 164
/S
key is all that is needed to start or stop a
TART
TOP
User Manual
78000010220 Rev. 023
3
27