Chapter 3 Reflectometry measurements
Activating the OTDR function
Activating the OTDR function
Once the OTDR module is correctly set onto the equipment and the T-
BERD/MTS is switched on, the desired OTDR function must be selected
before any OTDR configuration, or measurement.
Selecting the Smart Test function
Principle of the Smart Test
The Smart Test is used to perform OTDR acquisitions using a pre loaded
configuration file (no setup required) and access to essential analysis
features.
Selecting Smart Test
The Smart Test function is available whatever is the OTDR module set onto
the T-BERD/MTS.
To select this function, after the equipment starts:
1
Press the H
28
button.
OME
User Manual
78000010220 Rev. 023