Display Of Results And Command - Viavi 8100 V2 Series User Manual

The wavelength value is displayed.
Mode
270 Hz
330 Hz
1 kHz
2 kHz
Auto (the sources emit on determined frequencies to enable the
power meter to detect the wavelength used automatically)
Twintest (cyclical emission on all available wavelengths for a
few seconds on each wavelength), compatible with the Viavi
OLP 5/6/15/16/18.
CW (continuous emission)
The mode used is displayed, above the icon
PowerIn CW mode: You can choose the emitted power:
- either the nominal value: -3.5 dB
- or an attenuation of -3 or -6 dBm, with regard to this nominal
value, to get a power of 6.5 dBm or of 9.5 dBm.
For all the other modes (270Hz / 330Hz / 1kHz / 2 kHz / Auto /
Twintest), select one of the following emitted power: -12.5 , -9.5,
-6.5 dBm.
Source Reference

Display of results and command

The results page called up by the R
relating to the measurement in progress, results previously saved and the
commands available for measurement and saving.
To vary the mode of emission of the source. Possible
modulation values are:
Allows to access to the Standard Ref. menu key, to
perform the standard reference of the source.
User Manual
button, gives the information
ESULTS
78000010220 Rev. 023
Chapter 17 OFI Module
LTS function
.
527