Chapter 7 FiberComplete Modules
Performing the tests
Loading a configuration file FiberComplete
To load a configuration file previously created and apply parameters to new
tests with FiberComplete function:
1
Press F
2
Select the configuration file desired
3
Press
•
Press S
saved in the configuration file.
•
Select Setup page to display the file storage parameters saved in the
configuration file.
You can modify some acquisition or file storage parameters, and save
them in a new configuration file (see
tion" on page
NOTE
Some Viavi pre-defined configuration files for FiberComplete are
already available into the equipment, in F
FCOMP.
Performing the tests
Once Setup is configured on both units, they can be linked to the fiber to
be tested.
Press R
ESULTS
250
hard key
ILE
Load
>
Load Config.
hard key to display the OTDR acquisition parameters
ETUP
248).
hard key to display the FiberComplete results page.
User Manual
"Saving parameters from configura-
78000010220 Rev. 023
disk > config >
ILE