Unpacking The Device - Precautions; Fitting And Removing A Module (Not Available With Smartotdr); Fitting A Module - Viavi T-BERD/MTS 2000 User Manual

Chapter 2 Starting up

Unpacking the device - Precautions

Unpacking the device - Precautions
We suggest that you keep the original packing material. It is designed for reuse (unless
it is damaged during shipping). Using the original packing material ensures that the
device is properly protected during shipping.
If another packaging is used (for returning the equipment for example), Viavi cannot give
warranty on good protection of the equipment.
If needed, you can obtain appropriate packing materials by contacting Viavi Technical
Assistance Center.
Fitting and removing a module (not available with
SmartOTDR)
The MTS/T-BERD must be switched off, and if it is operating on the
mains, its supply cable must be unplugged.

Fitting a module

1 Turn the instrument face down on the work surface.
2 Set the two notches on the module part (1a) into the two holes provided for that
purpose on the Base (1b).
3 Make flush the 2 connections (2a & 2b), on module and base.
4 Once positioned, fix the module to the base screwing the 2 screws (3a) fixing the
receptacle.
5 With a T-BERD/MTS 4000 V2, repeat the process if a small module must be
installed at the back of the platform.
8 User Manual 77000010208 Rev. 012