Automatic Configuration; Saving Parameters From Configuration - Viavi 8100 V2 Series User Manual

Chapter 7 FiberComplete Modules
Configuring the units
If the parameter Table View is defined on Cable: [Cable_Id]
See
As soon as the Cable Id changes, the result table is cleared and the
next tests are stored with the new Cable Id name.
The name of the file is displayed in grey under Filenaming parameter

Automatic configuration

Press the key Auto Setup to configure automatically the acquisition
parameters as follows:
• Lasers: All
• IL/ORL Measurement: IL/ORL Bidir.
• Length Measurement: Yes
• Distance: Yes
• OTDR Measurement: None
• Fault Finder: No
• Table View: Fiber
• Thresholds: Default

Saving parameters from configuration

Once the File and Measurement parameters are configured, it can be
saved in a configuration file.
This configuration file can then be recalled for future acquisition in Fiber-
Complete mode.
To save parameters in a configuration file:
1 If File page is displayed, press S
248
"Table View" on page
User Manual
245)
to return to Setup page.
ETUP
78000010220 Rev. 023