Loading A Saved Configuration - Viavi T-BERD 5800 Manual

4. Antenna Test
5. Waveform
6. Return
7. Save Profile
8. Continue

Loading a saved Configuration

1. Run Wizard
Technical Support
Select the Transmit Antenna to test
Set the Waveform to LTE-FDD TM3.1 (NOTE TM3.1 is required for
FULL OCNS channels to test VSWR and PIM)
Press the
To save the configuration in the Save Profiles screen, enter a Filename,
and tap
After saving the profile Press the press the
advance to the test screen
GOTO Section 2 BBU Emulation
Load a save configuration by pressing the
Configuration from a Profile" area
NOTE: If a configuration for the RRH does NOT exist, proceed Section
4 Creating a New RRH Configuration
Select the configuration and press the
Press the button to accept the configuration
Press the
GOTO Section 2 BBU Emulation (Next page)
button to proceed to the Save Profile screen
, tap , and tap
button to advance to the next screen
tac@viavisolutions.com
twice.
arrow to
button under the "Load
button
1-844-468-4284