Automatic Configuration - Viavi T-BERD/MTS 2000 User Manual

Default Filename for FCOMP results
Filenaming convention in Fiber View
In Fiber View, the filenaming convention is as follows:
[Fiber_Id][Fiber_Num]
Filenaming convention in Cable View
In Cable View, the filenaming convention is as follows:
[Cable_Id]
As soon as the Cable Id changes, the result table is cleared and the next tests are stored
with the new Cable Id name.
The table view can be modified in the Setup page (see
Filenaming convention for Fault Finder results
If the fault finder is selected, the fault finderresult is using the following filenaming
convention:
[Cable_Id][Fiber_Id][Fiber_Num]
The name of the file is displayed in grey under Filenaming parameter

Automatic configuration

Press the key Auto Setup to configure automatically the acquisition parameters as
follows:
• Lasers: All
• Loss Measurement: Bidir.
• ORL Measurement: Bidir.
• Distance: Yes
• OTDR Measurement: None
• Fault Finder: No
• Table View: Fiber
• Threshold: Default
User Manual
Chapter 11 FiberComplete Modules
Figure 117 on page
77000010208 Rev. 012
Configuring the units
193).
205