Crease-Guard Stop. Rinse Hold Function; Stop And Door Opening Modes - GIRBAU HS-6013 Operation Instructions Manual

4.6. Crease-guard stop. RINSE HOLD function

This function allows interrupting the program from advancing before the final spin cycle of the program starts.
During the interruption time, the washing machine stops the movement of the drum, except for short rotation
movements at very large intervals, keeping the drain closed and the bath inside.
Possible interventions:
The function is activated by the keys on the multi-function keyboard.
To activate the function, press the

.
Once program interruption is activated, the

program.
To deactivate the function before the program is interrupted, press the

will change to

4.7. Stop and door opening modes

Description of the washing machine's different stop modes.
End of cycle. Stopping the washing machine functions after the wash cycle ends. The washing machine control
circuit remains in operation.
Door opening. After the bath has been drained and the drum rotation has ended, the door lock is released,
allowing the door to open.
External end-of-cycle signal. It is possible to use one of the machine's control outputs to issue an end of
program or an alarm signal (consult the authorised technical service for connecting this device).
This signal device will remain permanently connected to the end of cycle, providing the door is unlocked.
If an alarm is triggered, this signal device will come on intermittently.
Pressing the STOP key. This interrupts the wash cycle in operation and opens the washing machine's drain
valve. The washing machine control circuit remains in operation.
Door opening. After the bath has been drained and the drum rotation has ended, the door lock is released,
allowing the door to open.
NORMAL STOP switch. Switch installed on the front piece of the washing machine. Disconnect the washing
machine control circuit. DOES NOT DISCONNECT the entire electric circuit of the machine.
Door opening:
Models with safety delay by means of thermal device (HS-6013, HS-6017, EH030 and EH040). After a
maximum safety time (at times surpassing 3 minutes), the washing machine lock is unlocked.
Other models: Connect the ON switch again. After a maximum safety time (at times surpassing 3 minutes),
the washing machine lock is unlocked. In NORMAL STOP condition the door is not unlocked.
Emergency stop. Red button with lock located in a visible and accessible place on the washing machine. It
interrupts the operation of the washing machine. Once the switch is unlocked, the wash program resumes by
pressing the PROG key of the multi-function keyboard; the STOP key cancels de program.
Door opening:
Pushing the STOP key and after a maximum safety time (at times surpassing 3 minutes), the washing
machine lock is unlocked.
General stop. General switch located on the rear part of the washing machine. TOTALLY disconnects the
electric supply of the machine. Suitable for maintenance interventions and in situations of prolonged machine
stoppage.
Door opening:
Models with safety delay by means of thermal device (HS-6013, HS-6017, EH030 and EH040). After a
maximum safety time (at times surpassing 3 minutes), the washing machine lock is unlocked.
Other models: In GENERAL STOP condition the door is not unlocked. If the washer's electrical supply can
not be connected, the safety lock will have to be manual unlocked. Refer to chapter 14.
Executing Programs
key FOR SOME SECONDS. The key message will change to
.
key will blink. Press this key in order to resume the
19
key. The key message
Code 429159
Rev. 15/0717