Table of Contents
Advertisement
3.8. Initial start-up
THE WASHER MUST BE PUT INTO SERVICE BY AN AUTHORIZED TECHNICAL SERVICE.
Before the initial START-UP, make sure that you accomplish the following points:
Remove all packing materials. (Break them down in order to appropriately recycle them)
•
•
Remove all tools used during the installation.
•
Verify that all accessories have been removed from the drum interior.
Verify the correct installation of all the accessories necessary for the washer operation.
•
Check that the electrical installation corresponds with the voltage and the frequency of the machine.
•
•
Verify that the four washer feet come in contact with the floor.
•
Verify that all the shipping restraints are removed.
Connect all the water, steam (steam heated washers) and power inlets according to the technical
•
specifications.
Open the manual water inlet valves (and steam if necessary) and check for any leaks around the manual
•
flow valves and connection couplings.
•
Connect the electricity supply.
Check the operation (it is recommended to use the TEST program).
•
Keep the manual in a safe place and in good condition for its possible consultation.
•
Before washing clothes for the first time we recommend to run a complete cycle with detergent (1/4 the
•
normal recommended amount).
3.9. Emergency stop in coin-op installations
IN ACCORDANCE WITH SAFETY REQUIREMENTS FOR INDUSTRIAL MACHINERY STANDARD (UNE-
EN ISO 10472-1,5-2) AND OTHER SAFETY REQUIREMENTS, THE LAUNDRY OWNER / USER IS
RESPONSIBLE FOR INSTALLING A REMOTE LOCATED EMERGENCY STOP DEVICE, CONNECTED
TO EACH MACHINE.
Device conditions
To be located in a visible place, separated from all machines and easily accessible.
To break the electrical supply for all machines.
To safely isolate all machines at maximum consumption.
To require a RUN order for a new connection for the whole installation once the Emergency Stop button is
unlocked.
3.10. Wash cycle start-up from an external device to the washing machine
VERY IMPORTANT !!!
Washing machine cycle start-up should only be started by voluntary activation using an actuating
element designated for this purpose.
For machines connected to a remote control start-up system (e.g. a central vending point, etc.), the
control must be located so as to ensure that the operator may be absolutely certain that no person is
exposed to any dangerous area of the washing machine (pursuant to Machine Directive 2006/42/CE,
Annex 1)
3.10.1. Connecting to a central vending unit and configuring the machine
Consult the manual for INSTALLING AND CONFIGURING THE VENDING CIRCUIT part number 430731.
Installation
47
Cod.nº 429043
Rev. No. 21/0519
Advertisement
Table of Contents
