Greasing The Bearing Housing - GIRBAU HS-6013 Operation Instructions Manual

HS-6013, HS-6017, HS-6023, HS-6024, HS-6032, EH030, EH040, EH055 EH060, EH080 models
Disassembly and assembly
 Open the fastening clasps on the top cover. The
dispenser is now accessible.
 Dismount the siphon tubes from
compartment by pulling them upwards.
 To clean the lower basin, remove the leak seal and
separate the two dispenser bodies by separating
the side lips (see figure).
Once the cleaning operations are over:
 Remount the two dispenser bodies and check that
the side lips fasten both pieces.
 Replace the siphon tubes.
 Check that the dispenser is set well in its bracket.
 Check condition of top cover seal. If seal is
damaged, deformed or has lost elasticity, it must be
replaced. Replace the seal.
 Assemble the top cover. Close the clasps.
VERY IMPORTANT
The protection of the dispenser seal is necessary to prevent humidity and corrosion inside the
machine and the premature damage of the electrical and electronic circuits of machine control.

15.6. Greasing the bearing housing

Operation reserved for the Authorised Technical Services or the trained Customer Technical
Service.
In models HS-6110/EH255 models the bearing housing needs to be greased on a regular basis as a preventive
maintenance action to ensure smooth operation and the longest useful life. To do so, apply the amounts of Shell
Alvania 3 grease or similar which appear in the following table:
Every 5000 hours
Change oil seals
*
When changing oil seals: CHANGE USED GREASE and thoroughly clean the bearing housing.
Maintenance
the liquid
QUANTITY
A
120 g (0.265 lb) 80 g (0.176 lb)
1200 g (2.65 lb) 700 g (1.54 lb)
B
80
Fig. 15.1
Fig. 15.2
Code 429159
Rev. 15/0717