Duration Of The Dosing - GIRBAU HS-6013 Operation Instructions Manual

Dosing of products by means of the washing machine dispenser. (Internal dosing)
Dosing icons identify the dispenser compartment.
No dosing in the phase
<<< Option programmed by default
Dosing in powder product compartment (dosage 1)
Dosing in powder product compartment (dosage 2)
Dosing in liquid product compartment (dosage 3)
Dosing in liquid product compartment (dosage 4)
Washing machines with an external dosing system
The INTELI control allows activating four electric signals to control an external dosing system. The connection
board A4 of these four signals is installed as standard in all the washing machines and located at the rear side
of the machine. Consult the location and characteristics of the connection in the corresponding Installation
Manual.
The external dosing signals programming is independent of product dosing programming through the washer
dispenser.
The number that appears in the icons corresponds with the number of the label attached next to the connection
terminals.
Dosing by external dosing system
Expanding the number of external dosing signals. The number of electric external dosing control
signals can be increased to a maximum of twelve. To have the additional eight signals available, the A6(I/O2)
inputs and outputs board needs to be enabled in the SETUP menu.
Refer to the TECHNICAL ASSISTANCE- SELECTING SETUP CONTROL – TEST PROGRAM SETUP.
In models HS-6013 HS-6017, EH030 and EH040, expanding the external dosing signals is an option, on other
models it comes as standard.
For advanced use of the inputs and outputs board A6(I/O2), see Section 7.5 and the appendices of this manual.

7.3.6. Duration of the dosing

Optional programming
In default configurations, the time of each dosing is set at 40 seconds.
However, the INTELI control allows programming the length of each dosing.
This function appears after product dosing has been programmed, only if the parameter has been activated in
CONFIGURATION.
Programmable time range: 1 – 231 seconds
Value programmed by default: 1 sec.
Programming a new wash program
40
Code 429159
Rev. 15/0717