GIRBAU HS-6013 Operation Instructions Manual page 75

ALARM MESSAGE
INVERTER DETECTION
RELAY FAILURE
FAULT DETECTION A5
(I/O1) BOARD
BOARD A5 (I/O1)
COMUNIC.FAILURE
FAULT DETECTION A6
(I/O2) BOARD
BOARD A6 (I/O2)
COMUNIC.FAILURE
FAULT DETECTION A10
(TILT) BOARD
BOARD A10 (TILT)
COMUNIC.FAILURE
INVERTER
IDENTIFICATION ERROR
UNBALANCE CONTROL
FAILURE
UNBALANCE SWITCH
FAILURE
BATH LEVEL FAILURE
TEMPERATURE PROBE
FAILURE
DOOR LOCK FAILURE
WATER FAILURE
BATH OVERLEVEL
HEATING FAILURE
BATH
OVERTEMPERATURE
DRAIN FAILURE
Troubleshooting
LIKELY CAUSE
Washing machine microprocessor failure
Board I/O1 failure
Main board connection circuit failure
Connection failure
SETUP error
Board I/O2 failure
Main board connection circuit failure
Connection failure
A10 Board (TILT) failure
Main board connection circuit failure
Connection failure
Inverter model not compatible with the
washing machine model
Inverter identification plug failure or error.
Inverter detects an unbalance
outside the established limits
Unbalance detection circuit failure
Level control device failure
Temperature control device failure
Door badly closed
Door lock device failure
Water supply failure
Water inlet valve failure
Level control device failure
Water or dosing inlet valve lock failure
Level control device failure
Electric heating system failure
Steam supply failure
Steam valve failure
Temperature control device failure
Failure in heating system
Temperature control device failure
Machines with steam heating: steam inlet
valve obstructed
Drain pipes or valve obstructed
Drain valve failure
Disconnect the washing machine supply (note 1).
If the problem is not solved or if it repeats: call the
Authorised Technical Service.
Disconnect the washing machine supply (note 1).
If the problem is not solved or if it repeats: call the
Authorised Technical Service.
Disconnect the washing machine supply (note 1).
If the problem is not solved or if it repeats: call the
Authorised Technical Service.
Disconnect the washing machine supply (note 1).
If the problem is not solved or if it repeats: call the
Authorised Technical Service.
Disconnect the washing machine supply (note 1).
value
If the problem is not solved or if it repeats: call the
Authorised Technical Service.
Call the Authorised Technical Service.
Disconnect the washing machine supply (note 1).
If the problem is not solved or if it repeats: call the
Authorised Technical Service.
Call the Authorised Technical Service.
Disconnect the washing machine supply for at least
2 minutes.
Open and close the door again.
Check the state of the door seal.
If the problem is not solved or if it repeats: call the
Authorised Technical Service.
Check water entry pressure.
Check manual water inlet valves.
Check the state of the filters at the water inlet filters.
If the origin of the problem is not detected, contact
the Authorised Technical Service.
Close manual water inlet valves.
Call the Authorised Technical Service.
Machines with electric heating: Call the Authorised
Technical Service.
Machines with steam heating: check steam supply
pressure and steam inlet filter.
If the origin of the problem is not detected, contact
the Authorised Technical Service.
Call the Authorised Technical Service.
Machines with steam heating: close manual water
inlet valves.
Check drain pipes.
If the origin of the problem is not detected, contact
the Authorised Technical Service.
75
RESPONSE
Code 429159
Rev. 15/0717