Programming A Program Phase; Water Inlet - GIRBAU HS-6013 Operation Instructions Manual

Possible programming
No (Load detection off or fabric different from the following options)
<<< Option programmed by default
Poly-cotton
Cotton
Polyester/Synthetic
Mixed (Mixture of the previous options)

7.3. Programming a program phase

The program and the phase that are being programmed appear at the upper part of the screen.
The distinct programmable options at each operation appear simultaneously on the washing machine screen.
The options are selected with the arrow keys. The icon of the option selected appears in white on a black
background.
The icon of the numerical keyboard indicates that the option or value must be selected with this keyboard.
Once the desired operation is selected, confirm the programming. The next operation is accessed.
To finish programming, executing the end of phase screen is essential (section 7.3.18).
Any other end of program mode will cause the washing machine to operate erroneously.
Optional programming.
this function might not appear during the programming process depending on the options in the
CONFIGURATION menu (section 10.2) or the SETUP menu. (To learn more details about the SETUP menu:
consult the Technical Assistance Service).

7.3.1. Water inlet

Possible programming
No water inlet
Cold water inlet
<<< Option programmed by default
Hot and cold water inlet mixture depending on the temperature programmed.
Value of parameter A2 = HOT in SETUP menu. Factory value.
Cold water inlet through inlet 2
Only if value of parameter A2 = COLD in SETUP menu.
Third inlet option. Optional programming
The third water inlet option permits connecting the washer to a third water supply and to program the water
intake from this third inlet.
Programming a new wash program
Attention message that appears when programming some operations. It warns that
37
Code 429159
Rev. 15/0717