Tilt Hinge Assembly; Hold Down Base Securing (Figure 4.5) - GIRBAU HS-6085 Installation Instructions Manual

Tilt hinge assembly

Lift the washer and remove the crating (refer to chapter
2 about machine's transport).
Place the machine on wooden pieces (B/Fig. 4.3) so
the four supporting bases stay free and separated from
the floor: value A: 8 inch (200 mm) minimum This
clearance will permit the tilt hinges assembly.
Figure 4.4 shows a front view of the machine's front
right support.
Connect each of the four hinges A to each of the

machine supports B. The four hinges are identical.
Mounting screws D M14x55.
When assembling, each wheel's shaft C remain in
cross position.
Take special care in aligning the hinges edges with

machine supports edges.
If machine needs being levelled to compensate the

floor irregularities, install the levelling supplement
parts E between the hinge and the machine support.
Hold down base securing
The arrow indicates the front of the machine.
Place the holding down bases A and B on the floor

where the machine is to be installed. The holding
down bases are equal two against two and are
matched in X form. To determine each of the four
bases position, take as a reference the tilt guards
supports C.
Once the machine is placed on these four bases,

without moving it, drill holes in the bases for hold-
down metallic studs; three per base. Metallic studs
external diameter; 17 mm. The holes must be
perpendicular to the floor.
Replace the metallic studs washers by the furnished

washers: 13 x 34 mm. Secure the bases to the floor
with the metallic studs.
Tilt system assembly
(Figure 4.5)
48
Fig. 4.3
Fig. 4.4
Fig. 4.5
Cod. 511485
Rev. 10/0918