Tilt + Easy Load System Operation - GIRBAU HS-6013 Operation Instructions Manual

4.13. TILT + EASY LOAD system operation

Operation using the
control panel
The loading system must always be started with the door open. If the main menu window is displayed,
press the OK key to go to the PROGRAM EXECUTION MODE.
The LOAD and UNLOAD options are displayed on the screen.
Starting the loading sequence
Load the washing machine and press the LOAD key on the control panel or
activate the selector corresponding to the figure on the remote control. Close the
door.
Select the type of water. The water used in the Easy Load process is kept in the machine to be
used in the washing cycle.
Water inlet A1 (cold)
Water inlet A2 (hot and cold water depending on the washer connections)
Water inlet A3
Press the OK key.
Loading sequence time remaining.
Once the sequence has ended, the door can be opened without emptying the bath water.
Pressing the STOP key while the loading sequence is running halts this operation without
emptying the bath water.
Pressing the STOP key a second time opens the drain valve and empties the bath water.
ATTENTION! The LOAD sequence cannot be repeated.

Access to the list of programs.
Select and start a washing program. It will start without losing the bath water.
Executing Programs
Operation using the
remote control
Code 429159
Rev. 15/0717
27