Maintenance; Washing Machine Cleaning; Door Seal Cleaning - GIRBAU HS-6013 Operation Instructions Manual

15. MAINTENANCE

Caution
 The users must refrain from carrying out actions reserved for the Authorised Technical Services.
 Before performing any work on the washing machine, disconnect and mechanically lock the
external switch, and close and mechanically lock the manual water inlet valves.
Check the temperature of the parts to be handled, to avoid the risk of burns.

 The dispenser may contain residues of chemical products. When cleaning this component, avoid
direct contact with the skin and use eye protection.
 The draining pump and valve may contain residual water. When handling these components,
avoid direct contact with the skin and use eye protection.
 Remember to reassemble ALL of the panels and place them correctly after any maintenance
work.
 It is highly recommendable asking the Authorised Technical Service a register or report of all the
maintenance and service work done on your washer.
Operations described
USER-MAINTENANCE INSTRUCTIONS
 Cleaning the washer (Section 15.1)
 Cleaning the door seal (Section 15.2)
 Cleaning the solenoid valve filters (Section 15.3)
 Checking safety devices (section 15.4)
ONLY TO BE PERFORMED BY AUTHORISED TECHNICAL SERVICE
 Cleaning the dispenser (section 15.5)
 Greasing the bearing housing (section 15.6)
 Checking the condition of the bearing housing seals (Section 15.7)
 General revision (Section 15.8)
 Recovery tank cleaning (section 15.9)

15.1. Washing machine cleaning

 We recommend periodic cleaning of the outside of the washing machine. Use a damp cloth or sponge.
 To remove traces of grease, use mild soap and rinse as required.
 Never use abrasive products or tools that could scratch or damage the surface of the washing machine.

15.2. Door seal cleaning

 Use a damp cloth or sponge.
 Be especially careful to remove traces of laundry products or pieces of fabric that could be caught
between the folds of the seal.
 Never use abrasive products or tools that could cut or damage the seal.
Maintenance
77
Code 429159
Rev. 15/0717