Manual Modification - GIRBAU HS-6013 Operation Instructions Manual

4.5. Manual modification

MANUAL MODIFICATION is understood as meaning the modification of the value of a function of the phase
being run.
This option allows the user to intervene immediately in the phase being run, modifying the values of the water
input, dosing, bath draining and temperature functions programmed. For example, to increase the temperature
of a wash phase, increase the level of rinse water, clean the dispenser compartment, etc.
The modified values will return to their original state at the end of the program.
This option is available on models with microprocessor Version 21D/21F or later.
In no case will it be possible to access the manual modification of the phase if the program is in:
 the process of water input and has not yet reached the programmed bath level.
 a draining or spinning process.
0ºC


Use the multifunction keypad's
Activate the function selected using the numerical keypad.
To activate the functions of water input, dosing and draining, keep the key on the numerical
keypad held down.
Manual modification functions
Water input. Press the 1 key to activate the A1 cold water input. Press the 2 key to activate the
A2 hot water input.
ATTENTION! The A2 hot water input comes directly from the mains supply, without mixing. The
temperature of the water may be high.
Internal/external dosing.
Selecting this function will activate the MOD option on the screen allowing the user to change the
type of dosing.
Activate the dosing required using the numerical keypad.
In external dosings it is only possible to activate Signals d1 to d9.
Draining.
Press the 1 key to open the washing machine drain.
Temperature (machines with heating only).
Enter the temperature value desired using the numerical keypad.
Confirm the temperature programmed by pressing the
(Consult the meaning of the icons in Sections 7.3.1, 7.3.3, 7.3.5, 7.3.14)
ATTENTION!! Manual modification functions may vary depending on the way the washer is configured.
Executing Programs
Press i and then MAN to access the MANUAL
modification screen.

keys to select the desired function.
key.
18
Code 429159
Rev. 15/0717