Example Of Using Multiple External Dosings Of Different Durations - GIRBAU HS-6013 Operation Instructions Manual

A.2.2. Example of using multiple external dosings of different durations
Based on example A.2.1, if the products being used via the external dosing require different dosing times, then a
sufficient number of phases need to be created to regulate this time. Let us suppose that d6 and d8 need to be
triggered in the same phase and require a dosing time of 10 seconds, whereas d11 and d12 require a time of 20
seconds, and therefore their triggering should be performed in a different phase from d6 and d8. To adapt this
information to the program, proceed as illustrated in the following table:
Pr 3
Ph
1 2 3 60
2 2 3 60
3
1 5 0
4 1 5 0
5 2 4 0
Phase Symbol Value
1
5
2
Ph1
15
10
10
Phase 2 will begin after all the functions programmed in the previous phase have been run: the level and
temperature of the bath and the dosing of the different products.
192
Ph2
20
td: Indicates the dosing time established by default.
Appendices to the manual
140 1 5 2
140 0 0 0
32 0 0 0
32 0 0 0
32 4 td* 0
Description
Selection of first dosing, powder product compartment.
Duration of the first dosing. In this case, 5 seconds.
Selection of second dosing, powder product compartment.
Duration of the second dosing. In this case, 15 seconds.
Selection of the A6(I/O2) board signals that must be activated. If the table in
Section 7.4.3 is consulted, it will show that 10 corresponds to Outputs d6 and d8.
Dosing time: 10 seconds. Outputs d6 and d8 are triggered in the same phase and
will both have the same duration.
In this case, 192 means that Outputs d11 and d12 of the A6(I/O2) board will be
triggered.
Dosing time: 20 seconds. Outputs d11 and d12 are triggered in the same phase
and will both have the same duration.
15 10 10 5
0 192 20 5
0 0 0 5
0 0 0 5
0 0 0 5
48 min

0 0 0 --
6 0 0 2
2 0 1 1
2 0 1 1
3 0 1 6
Code 429159
Rev. 15/0717
85
--
2
1
1
9