Locking And Unlocking The Use Of A Program; Erasing A Program; Modifying The Name And Viewing The Content Of Pre-Set Programs - GIRBAU HS-6013 Operation Instructions Manual

8.3. Locking and unlocking the use of a program

Option that allows the user to lock the use of one or more selected programs, using an access code. See
Section 10.5 MANAGING ACCESS CODES.
Locking usage
From the main menu (Section 4.1), select the icon corresponding to the PROGRAMMING mode
(Section 6.3). The icons for the different menus are displayed.
Select the MODIFICATION icon.
The icons of different modification options will appear.
Consult the general map of the MODIFICATION menu in Chapter 8.
Select the LOCKING icon. The program list will appear.
Select the program to be locked using an access code.
Press the
selected program number, indicating that the program is protected by an access code.
The machine is ready again to lock a new program.
To unlock a locked program, select the program and press the
icon will disappear.
To quit the option, access the upper menu by pressing the
On running a locked program, the message ENTER ACCESS CODE appears on the screen.
Type in the access code entered in the UNLOCKING CODE MODIFICATION menu and then press the
key.
The option for locking using an access code is only available on models with microprocessor Version 21D/21F
or later.

8.4. Erasing a program

Eliminate the contents of programs set by the user (up to number 79).
Before executing the order, the microprocessor requests confirmation to erase. If erasure is confirmed, the
content of the program is IRRECOVERABLE.
The content of the last twenty programs cannot be deleted.
Erasing a program
From the main menu (section 4.1), select the icon corresponding to the PROGRAMMING mode
(section 6.2).
Select the MODIFICATION icon.
The icons of different modification options will appear.
Consult the general map of the MODIFICATION menu in the start-up section of chapter 8.
Select the ERASE icon. The program list will appear.
Select the program you want to erase. Confirm the selection.
The following screen prompts confirmation to erase.
?
Confirm to erase the program contents.
The machine is ready again to erase a new program.
To quit the option, access the upper menu by pressing the

8.5. Modifying the name and viewing the content of pre-set programs

The twenty pre-set programs are not modifiable; however, modifying the name and/or viewing their
content is possible.
Once a phase is selected, the icon indicates that modifying its content is not possible.
The key allows successively viewing the content of the phase.
To finalize viewing the content of the phase, accessing the end of phase screen (7.3.18) is
imperative.
Modifying programs
key to confirm the locking order. The lock icon appears next to the
key. The locking
key.
key.
Code 429159
Rev. 15/0717
53