Modifiable Values Tables - GIRBAU HS-6013 Operation Instructions Manual

10.2.3. Modifiable values tables

BATH LEVELS
Modifying the value of the six bath levels within the established limits is possible, always respecting the
ordering criteria from lowest to highest. The value of each level in millimetres must always be higher than
the lower level and smaller than higher level.
The programmed height of the bath is approximately equivalent to the height of the water visible through the
lower part of the drum, expressed in millimetres.
These values must be checked with the drum stopped (programming NO rotation in the phase).
Values programmable by the numerical keyboard.
Programming limits and table of factory settings depending on the machine model.
LEVEL
HS-6013 HS-6017
EH030 EH040
L1 36 38
L2 66 78
L3 95 110
L4 122 140
L5 147 167
L6
172 195
L max 239 271
Example of programming levels>>>>>>>
(based on a washer HS-6017 / EH040 model)
ATTENTION!
In certain machines with a heating system the L1 level and L2 level are increased.
LEVE
L HS-6013 HS-6017
EH030 EH040
L1 66
L2 68
ATTENTION!
Increasing the bath levels increases the water and energy consumption of the washing machine.
The habitual usage of the bath level greater than the default value of level 6 considerably reduces the life of
the seals and bearings.
Do not increase the level values if it is not absolutely necessary.
System tools
level values by default in mm
machines WITHOUT heating system
HS-6023 HS-6024
EH055 EH060
16 58
54 100
88 133
120 166
155 199
187 230
187 293
level values by default in mm
machines WITH heating system
HS-6023 HS-6024
EH055 EH060
16
58 66
54
78 100
HS-6032 HS-6040 HS-6057
EH080 EH090 EH130
70 41 17
114 91 75
153 136 128
190 178 176
225 217 222
259 252 265
323 235 323
Programmable L3 (level 3) range:
min:
HS-6040 HS-6057
EH090 EH130
41 17
91 75
programmable
ranges
HS-6110
minimum maximum
EH225
8
L1 L2 – 1mm
75
L1 + 1mm L3 – 1mm
143
L2 + 1mm L4 – 1mm
205
L3 + 1mm L5 – 1mm
263
L4 + 1mm L6 – 1mm
323
L5 + 1mm
380
-----
L2 + 1= 79mm.
max: L4 – 1= 139mm.
programmable
ranges
HS-6110 maximu
minimum
EH225
8 L1 L2 – 1mm
75 L1 + 1 mm L3 – 1mm
Code 429159
Rev. 15/0717
63
L max
-----
m