Rotation. Start – Stop Sequence - GIRBAU HS-6013 Operation Instructions Manual

7.3.7 Rotation. Start – Stop Sequence.
This function allows selecting distinct start-and-stop drum rotation sequences.
The programmed sequence is maintained during the entire phase.
There are five pre-programmed rotation sequences that are modifiable in the CONFIGURATION of the
washing machine.
Value ON: drum rotation time in seconds.
Value OFF: drum stoppage time in seconds.
Programmable reverse sequences
No rotation.
There is no drum movement.
Reverse sequence 1
Reverse sequence 2
Reverse sequence 3
Reverse sequence 4
Reverse sequence 5
< < < Option programmed by default
7.3.8. Rotation speed.
Programming this function is only possible if the parameter has been activated in CONFIGURATION and a
rotation value has been programmed.
Allows selecting a rotation speed in the wash cycle, among four pre-programmed speeds
These speeds are modifiable in the CONFIGURATION menu.
As for the load, the nominal value of the programmed speed can reduce approximately 5 r.p.m.
Possible programming and rotation speeds
Rotation speed 1
Rotation speed 2
Rotation speed 3
Rotation speed 4
< < < Option programmed by default
7.3.9. Rotation time.
The rotation time starts when the programmed values for level, dosing and temperature have been reached.
Programmable time range: 0 – 99 minutes.
Value programmed by default: 1min.
Programming mode
WR1 ON: 5sec. – OFF: 55sec.
WR2 ON: 5sec. – OFF: 10sec.
WR3 ON: 5sec. – OFF: 25sec.
WR4 ON: 15sec. – OFF: 15sec.
WR5 ON: 25sec. – OFF: 5sec.
Optional programming.
WS1
WS2
WS3
WS4
Default values
Value by default depending
on machine model
HS-6013 / EH030
27 r.p.m.
36 r.p.m
43 r.p.m.
48 r.p.m.
26
HS-6017 / EH040
25 r.p.m.
34 r.p.m
40 r.p.m.
45 r.p.m.
Cod. 429159
Rev. 01/0306