Rotation Speed; Rotation Time; Gradual Cooling - GIRBAU HS-6013 Operation Instructions Manual

7.3.10. Rotation speed

Optional programming
Programming this function is only possible if the parameter has been activated in CONFIGURATION and a
rotation value has been programmed.
Allows selecting a rotation speed in the wash cycle, among four pre-programmed speeds. These speeds are
modifiable in the CONFIGURATION menu.
Depending on the load, the drum rotation speed can vary +/- 5 rpm regarding the programmed speed.
Possible programming
Rotation speeds in rpm
Speed 1 WS1
Speed 2 WS2
Speed 3 WS3
Speed 4
<<< Option
WS4
programme
d by default

7.3.11. Rotation time

The rotation time starts when the programmed values for level, dosing and temperature have been reached.
Programmable time range: 0 – 99 minutes
Value programmed by default: 1min.

7.3.12. Gradual cooling

Function that allows gradually reducing the bath temperature by admitting cold water up to 45ºC / 113ºF.
The cooling is executed once the rotation time ends and before the bath is drained.
This function is only programmable if the temperature programmed in the phase is greater than 50ºC / 122ºF.
Possible programming:
No gradual cooling
<<< Option programmed by default
Yes, gradual cooling
Programming a new wash program
HS-6013 HS-6017 HS-6023
EH030 EH040 EH055
23 23
30 30
37 37
44 44
HS-6024 HS-6032
EH060 EH080
22 22 21
29 27 26
36 36 36
43 42 42
42
HS-6040 HS-6057 HS-6110
EH090 EH130 EH225
19 18 17
26 24 22
33 30 27
40 36 32
Code 429159
Rev. 15/0717