Programming Mode; Defining Programming Concepts; Programming Mode Menus - GIRBAU HS-6013 Operation Instructions Manual

6. PROGRAMMING MODE

6.1. Defining programming concepts

Before programming new programs, it is important to be familiar with the main concepts involved in the process.
To understand the structure of Inteli control wash programs, two basic concepts must be defined: function and
phase.
Function: Each action performed by the washing machine during a program. Highlighting the most important

ones: filling with water, dosing of product, drum movement, draining, etc. The functions are always
performed following the same sequence or order of execution.
Phase: The grouping of the functions in the order in which they are performed is defined as a phase. The

total number of phases available in the Inteli control memory will vary depending on the options defined in
Configuration.
Association of phases: The great potential of this system lies in the possibility to program interconnected

phases, since not all the phases must necessarily finalize with a draining of the bath.
This feature allows carrying out modifications, within the same phase, such as: increasing the level or

temperature of the bath, dosing products at different moments within the same bath, varying the mechanical
action, etc.
Program: Group of phases grouped together in a defined sequence whose execution has the treatment of

the fabric as its objective. The maximum number of phases in each program is not previously defined.
Programming: programming is filling with content the functions that make up the phases of a program. It

can be done from an empty structure: programming a new program or modifying an already existing
program.
It must be mentioned that programs 80 to 99 are programmed at works and their content is unalterable.
There is, however, the possibility of copying them over an empty program and later modifying them.
Configuration: The SYSTEM TOOLS menu of INTELI control contains those parameters determining the

washing machine operation. Modifying the value of these parameters the operation of the washing machine
can be adapted to the needs of the users and using the machine's possibilities to the maximum.
By default, the washing machine leaves the factory with the basic configuration of operation options.
This configuration permits programming the washing machine with many possibilities but with great
simplicity.
Do not modify the configuration parameters without knowing exactly what the objective of the washing
machine operation is.

6.2. Programming mode menus

The PROGRAMMING mode screen allows choosing different options:
Programming mode
Programming a new program
Modifying existing programs
Using the card
34
Code 429159
Rev. 15/0717