Initial Start-Up; Emergency Stop In Coin-Op Installations - GIRBAU HS-6008 Installation Instructions And Information Manual

Initial Start-up

The washer must be put into service by an AUTHORIZED SERVICE TECHNICIAN.
Before the initial STARTING, make sure that you accomplish the following points:

Remove all packaging materials (Break them down in order to appropriately recycle them)

Remove all tools used during the installation.

Verify that all accessories have been removed from the drum interior.

Verify the correct installation of all the accessories necessary for the washer operation.

Check that the electrical installation corresponds with the voltage and the frequency of the machine.

Verify that the four washer feet come in contact with the floor.

Verify that all the shipping restraints are removed.

Connect all the water and power inlets according to the technical specifications.

Open the manual water inlet valves and check for any leaks around the manual flow valves and connection
couplings.

Connect the electrical supply.

Check the operation (it is recommended to use the TEST program).

Keep the manual in a safe place and in good condition for its possible consultation.

Before washing clothes for the first time we recommend to run a complete cycle with detergent (1/4 the
normal recommended amount).

Emergency stop in coin-op installations

IN ACCORDANCE WITH SAFETY REQUIREMENTS FOR INDUSTRIAL MACHINERY STANDARD (UNE-
EN ISO 10472-1,5-2) AND OTHER SAFETY REQUIREMENTS, THE LAUNDRY OWNER/MANAGER IS
RESPONSIBLE FOR INSTALLING AN EMERGENCY STOP DEVICE THAT AFFECTS ALL THE MACHINES
IN THE LAUNDRY.
Device features

To be located in a visible place, separated from all machines and easily accessible.

To break the electrical supply for all machines.

To safely isolate all machines at maximum consumption.

To need reinstating (the whole installation) after the Emergency Stop Push-button has been released.
Installation
22
Cod. 428938
Rev. 05/0717